Single ply roofing products are factory manufactured sheet products which can vary in composition; including rubber, plastics, and polyvinyl chloride. This type of roofing typically contains the impermeable properties as well as the finished surfacing in a single layer of product. The sheets sizes range from 5 ft up to 12 ft wide and in a larger range of lengths. These membranes can be mechanically attached or fully adhered with the laps/joints typically heat welded with hot air. This product is best used in low-traffic areas where servicing equipment is kept to a minimum. Due to the high reflectivity and emissivity properties, this is one of the most energy efficient as well as environmentally friendly “green products”. This product when mechanically attached is one of the quickest and least intrusive products installed as it is odorless and in large but manageable sheets. In the past five years, this type of product has been steadily overtaking traditional asphalt based products. Roofing contractors must be licensed to provide a material and labor warranties backed by the manufacturer. Prior to contracting a roofer ask to see a current copy of this certification. Brinkmann Quality Roofing Services has earned proper certification to enable us to provide our clients the best warranty’s available in the roofing industry.
Key Benefits:
- Highly reflective
- Rapid application
- Superior emissivity rating
- Resilient to ponding water
- Flexible application substrates
- Clean look and installation
- Cost efficient